STEP 1
STEP 2
STEP 3
• Apply some glue on the fuselage slot and the points of contact
for the stab. Glue the stab in place.
• Apply some glue in the slot and n contact points and glue the
vertical fin in place.
• Check for correct alignment.
• Fix the control horns to the vertical n and to the stabilizer and
click the retaining plastic on the other side of the control surfaces.
• Tighten the screw on the pushrod.
• Do not overtighten the nut on the control horn, some play is re-
quired.
• Secure the nut using cyano glue.
• Repeat these steps for the rudder.
• Connect the motor wires and observe the polarity. Fix the motor using the supplied screws..
GLUE
GLUE
To Next Page
Loading...