WELD SPOTS
Insert the assembled Ball Mount
into the Hitch and lock as normal.
Make sure the Weld Spots on
the Hitch Ball are pointed towards
the rear left side of your trailer
at about 10 o’clock.
HITCH BALL
PLACEMENT
FLUSH,
TIGHT,
NO GAP
HITCH CONNECTION
Turn the Ball Mount Counterclockwise
until the gap between the Ball Mount
Collar and Trailer Tongue closes
tightly, with no gap.
TIGHTENING BAR
Once the Ball Mount is secure,
use the Tightening Bar to ensure
the connection is as tight as possible!
This will take a few rotations.
TIGHTEN THE
BALL MOUNT
Have a Gap or Step Down Hitch
preventing a ush connection?
SEE PAGE 9
8
To Next Page
Loading...
