Parkside Performance PKHAP 20-Li C3 User Manual

PKHAP 20-Li C3
GB
│
CY
│
3 ■
Battery PAP 20 B3*
Type LITHIUM ION
Rated voltage 20 V
(DC)
Capacity 4 Ah (80Wh)
Cells 10
High-speed battery charger PLG 20 C3*
INPUT
Rated voltage 230–240 V
~
, 50 Hz
(AC)
Rated power
consumption 120 W
Fuse (internal) 3.15 A
T3.15A
OUTPUT
Rated voltage 21.5 V
(DC)
Rated current 4.5 A
Charging time approx. 60 min
Protection class II / (double insulation)
* BATTERY AND CHARGER ARE NOT INCLUDED
ATTENTION! Hot surface.
There is a risk of burns.
Noise emission value
Noise measurement value determined in accord-
ance with EN 62841. The A-rated noise level of
the power tool is typically as follows
Hammer-drilling
Sound pressure level L
pA
= 101.9 dB (A)
Uncertainty K = 3 dB
Sound power level L
WA
= 112.9 dB (A)
Uncertainty K = 3 dB
Total vibration value
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 62841:
(main handle)
Hammer-drilling a
h.HD
= 6.449 m/s
2
, K = 1.5 m/s
2
Chiselling a
h,CHeq
= 6.498 m/s
2,
K = 1.5 m/s
2
(additional handle)
Hammer-drilling a
h, HD
= 10.089 m/s
2
, K = 1.5 m/s
2
Chiselling a
h,CHeq
= 8.776 m/s
2,
K = 1.5 m/s
2
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
► Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece that is being worked,
the vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool.
► It is necessary to establish safety measures to
protect the operator based on an estimation
of the vibration load during actual use (all
states of operation must be included, e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).

Parkside Performance PKHAP 20-Li C3 Specifications

General

Battery Voltage	20 V
Max. Drilling Diameter in Wood	30 mm
Max. Drilling Diameter in Steel	13 mm
Max. Torque	60 Nm
No-load Speed	0-500 / 0-2000 rpm
Battery Type	Li-Ion
Chuck Size	13 mm
Chuck Capacity	13 mm
Torque settings	20