Parkside Performance PKHAP 20-Li C3 User Manual

PKHAP 20-Li C3
GB
│
CY
│
7 ■
Safety guidelines for battery
chargers
■ This appliance may be used by
children aged 8 years and above
and by persons with limited phys-
ical, sensory or mental capabili-
ties or lack of experience and
knowledge, provided that they
are under supervision or have
been told how to use the appli-
ance safely and are aware of
the potential risks. Do not allow
children to use the appliance as
a toy. Cleaning and user mainte-
nance tasks may not be carried
out by children unless they are
supervised.
The charger is suitable for
indoor use only.
WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or
asimilarly qualified person.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP20A1/PAP20A2/
PAP20A3/PAP20B1/PAP20B3/
PAPS204A1/PAPS208A1.
♦ A current list of battery compatibility can be
found at www.lidl.de/Akku.
WARNING!
■ Do not use any accessories which are not
recommended by PARKSIDE. This can lead to
an electric shock and fire.
Before use
Charging the battery pack
(seefig.A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack5 from or connect
itto the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient
temperature should be between 0°C and
50°C.
♦ Connect the battery pack5 to the high-speed
battery chargert (see fig. A).
♦ Insert the power plug into the socket. The
control LEDz lights up red to indicate that the
appliance is charging.
♦ The green LEDu indicates that the charging
process is complete and the battery pack5 is
ready.
♦ Push the battery pack5 into the appliance.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Push the rotation direction switch3 into the
middle position (lock).
Allow the battery pack5 to click into the
handle.
Removing the battery pack
♦ Press the release button4 and remove the
battery pack5.

Parkside Performance PKHAP 20-Li C3 Specifications

General

Battery Voltage	20 V
Max. Drilling Diameter in Wood	30 mm
Max. Drilling Diameter in Steel	13 mm
Max. Torque	60 Nm
No-load Speed	0-500 / 0-2000 rpm
Battery Type	Li-Ion
Chuck Size	13 mm
Chuck Capacity	13 mm
Torque settings	20