32
GB MT
even when the power supply is
switched off.
signs must be replaced.
parts for safety reasons. Use
only original spare parts and
accessories.
before you put the machine into
storage. Risk of burns!
Electrical Safety:
the rating plate.
a socket that has a
RCD (Resi-
with a trip
current of no more than 30 mA.
earthed parts (e.g. metal
increased risk of electric shock
if your body is earthed.
of H05VV-F, which are no more
outdoor use. The power cable
wire cross section must be at least
2x1,0mm
2
. Always completely
unroll cable drums before use.
Check the cable for damage.
the cable suspension intended
for the purpose.
from the cutting tool when work-
ing. The cutting blades may
damage the power cable and
result in contact with live parts.
Always run the power cable be-
hind the operator.
The extension cable can be
accidentally severed. Risk of
electric shock!
pull the plug from the socket.
Protect
the power cable from
heat, oil and sharp edges.
disconnect the plug from the
socket if the power cable is
damaged. If the power cable is
damaged, it must be replaced
by the manufacturer, the cus-
tomer services of the same, or
avoid hazards.
power cable to the mains. Do not
touch a damaged power cable
when it is connected to the mains.
A damaged power cable may
result in contact with live parts.
Residual risks
Even if properly operating and han-
dling this electric tool, some residual
risks will remain. Due to its construc-
tion and build, this electric tool may
present the following hazards:
parts;
ear protection;
-
piratory protection is not worn;
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
To Next Page
Loading...