Parkside 109801 - User Manual

Questions and Answers

E
Elizabeth SanchezAug 11, 2025
What to do if there is no material flow in my Parkside 109801?
- R
  randy04Aug 11, 2025
  If you're experiencing no material flow in your Parkside Power Tool, several factors could be the cause. First, the air might not be dry enough; in this case, install a water separator in your compressed air system. Second, the air pressure could be too low; increase the output pressure of your compressor. Third, the attachment might not be sitting correctly; ensure it's firmly on the appliance with no air escaping. Finally, the sand-blasting material pipes could be blocked; check for lumps and use a blow-out gun to clean them, remembering to wear safety goggles, and also inspect the tank outlet opening.
K
Kenneth JohnsonAug 20, 2025
Why is the sand-blasting pattern not as expected with my Parkside 109801?
- T
  Thomas PaulAug 20, 2025
  If the sand-blasting pattern isn't as expected with your Parkside Power Tool, consider these potential causes: The air might not be dry enough, so install a water separator in your compressed air system. The sand-blasting material grain size might not be uniform, so replace the sand-blasting material. The sand-blasting material might be impure, so clean or replace it. Finally, the attachment might be worn, so replace the attachment.
K
kellytaylorAug 31, 2025
What to do if Parkside 109801 Power Tool has no material flow?
- J
  justin20Aug 31, 2025
  If your Parkside Power Tool has no material flow, consider these possible causes and solutions: * The air might not be dry enough. In this case, install a water separator in your compressed air system. * The air pressure could be too low. Try increasing the output pressure of your compressor. * The attachment might not be sitting correctly. Ensure it is firmly on the appliance and that no air escapes at the sides. * The sand-blasting material pipes may be blocked. Check for lumps and use a blow-off gun to clean them, remembering to wear protective glasses. Also, inspect the outlet opening of the tank.