Why does my Parkside Thermometer show an incorrect temperature?
An incorrect temperature on the display of your Parkside Thermometer might be due to several reasons: a low battery (replace it with a new one), the product needing about 30 minutes to adjust to a new environment, or an unsuitable measuring surface (change it).
What to do if my Parkside Thermometer displays a blank screen?
If the display of your Parkside Thermometer is blank, it could be due to the battery being inserted incorrectly (insert it as shown on the battery cover) or the battery being drained (insert a new battery).
What to do if Parkside 306278 displays '----' and then 'OFF'?
If your Parkside Thermometer displays "----" for about 5 seconds and then "OFF" for about 3 seconds before turning off, it's likely that the ambient temperature is either too low or too high. Turn off the product, move it to a location where the ambient temperature is within the specified range, and allow it to stabilize for at least 30 minutes before turning it back on. The product should then function normally.
What to do if Parkside 306278 Thermometer shows incorrect temperature?
If your Parkside Thermometer displays an incorrect temperature, there are several possible causes. First, the battery may be low, in which case you should replace it with a new one. Second, you may not have allowed the product to acclimate to the environmental conditions for about 30 minutes after a drastic change in ambient conditions; allow the device to acclimate for the specified time. Finally, the measuring surface may not be suitable, so try changing it.
Why is the display blank on my Parkside 306278?
A blank display on your Parkside Thermometer can occur for two reasons: either the battery is inserted incorrectly (insert the battery as shown on the battery cover) or the battery is drained (insert a new battery).
How to fix Parkside 306278 Thermometer when it shows '----' and 'OFF' before turning off?
If your Parkside Thermometer shows "----" for 5 seconds and "OFF" for 3 seconds before turning off, it is likely that the ambient temperature is too low or too high. To resolve this, turn off the product and move it to a location where the ambient temperature is within the specified range. Allow the product to stabilize in the working ambient temperature range for at least 30 minutes before turning it back on. The product should then function normally.
General| Type | Infrared Thermometer |
|---|---|
| Distance to spot ratio | 12:1 |
| Battery type | AAA |
| Temperature Range | -50°C to +380°C |
| Laser Pointer | Yes |
| Power Supply | 2 x AAA batteries |
| Resolution | 0.1°C |
| Emissivity | 0.95 (fixed) |
To Next Page
