Parkside 391005 2201 - Technical Data and Charging Information

6
GB
CY
Technical data
Cordless
Hammer Drill ..........PKHAP 20-Li B2
Motor voltage U ..........................
No load speed n
0
Mode 1 ............................0 - 660 rpm
Mode 2 ............................0 - 950 rpm
Impact rate
Mode 1 ......................... 0 - 3265 bpm
Mode 2 ......................... 0 - 4700 bpm
Impact energy ............................. 3 joule
Weight (without battery) ..............2.84 kg
Drilling capacity
in concrete/stone .............. max. 24 mm
in wood ........................... max. 27 mm
in metal ........................... max. 13 mm
Sound pressure level
(L
pA
) ....................... 98.3 dB, K
pA
= 3 dB
Sound power level
(L
WA
) ....................109.3 dB; K
WA
= 3 dB

(a
h,HD
).............................. 10.072 m/s
2
(a
h,CHeq
) ............................... 8.92 m/s
2
...................................... K= 1.5 m/s
2

(a
h,HD
).............................. 19.408 m/s
2
(a
h,CHeq
) ............................. 14.88 m/s
2
...................................... K= 1.5 m/s
2
...........................
Charging process ...................
Operation .......................... 
Storage .................................
For use with smart batteries

Operating frequency/
Frequency band .....
Max. transmission power .......

measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.

also be used for a preliminary exposure
assessment.
Warning: 
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
 -
tions as low as possible. An example
of how to reduce vibration exposure
is limiting the working hours. For this
purpose all parts of the operating
cycle have to be considered (for ex-
ample, times when the electric tool
is switched off and times when it is
switched on but running without any
load).
Charging time



series.

series may only be charged using chargers

We recommend that you operate this appli-
ance with the following batteries only:


We recommend charging these batteries
with the following chargers:



An up-to-date list of battery compatibility
can be found at: www.lidl.de/akku