PABS 20-Li D5
■ 2
│
GB
│
IE
│
NI
│
CY
CORDLESS DRILL DRIVER WITH
ACCESSORY SET PABS 20-LiD5
Introduction
Congratulations on the purchase of your new
appliance. You have chosen a high-quality product.
The operating instructions are part of this product.
They contain important information about safety,
usage and disposal. Before using the product, please
familiarise yourself with all of the operating and
safety instructions. Use the product only as de-
scribed and for the range of applications specified.
Please also pass these operating instructions on to
any future owner.
Intended use
This appliance is designed for screwing and drilling
into wood, plastic and metal. The appliance may
only be used as described and for the specified
application areas. Any other usage of or modifica-
tion to the appliance is deemed to be improper
and carries a significant risk of accidents.
The manufacturer accepts no responsibility for
damage caused by incorrect use of the appliance.
This appliance is not intended for commercial use.
Features
Speed selector switch
Bit holder (magnetic)
Rotation direction switch/lock
ON/OFF switch/speed control
Belt clip
Battery charge level button
Battery display LED
Battery pack (2x)
Battery pack release button
LED work light
- Chuck
3 Torque preselection ring
! High-speed charger
. Red charge control LED
0 Green charge control LED
6 Replacement lead for pencil
1 Cutter knife
%Tape measure
+Centre punch
20a
Countersink
,Socket wrench set
75 mm bits
/ 50 mm bits
Metal drill set
"Bit holder
# 25 mm bits
$ Wood drill set
& Carpenter's pencil
Package contents
1 cordless screwdriver
1 high-speed battery charger
2 battery packs
20 bits (25 mm)
10 bits (50 mm)
10 bits (75 mm)
1 cutter knife
1 carpenter's pencil incl. 2 spare leads
1 tape measure (5 m)
8 socket wrench set
1 countersink
1 centre punch
Set of 5 wood drills
Set of 14 metal drills
1 carrying case
1 set of operating instructions
Technical data
Cordless screwdriver PABS 20-Li D5
Rated voltage 20 V
(DC)
Rated idle speed 1st gear n
0
0–400 rpm
2nd gear n
0
0–1400 rpm
Chuck clamping range
max. Ø 13 mm
Max. drill diameter Steel 13 mm
Wood 30 mm
To Next Page
Loading...
