Parkside PAHE 20-Li B2

Questions and Answers

S
Sharon JamesJul 29, 2025
What to do if my Parkside PAHE 20-Li B2 does not start?
- L
  larryedwardsJul 29, 2025
  If your Parkside Pole Saw doesn't start, the battery might be discharged. Try charging it, referring to the battery and charger's operating instructions. Alternatively, the battery might not be properly inserted; ensure it is correctly placed, again consulting the battery and charger's instructions. In some cases, the on/off switch may be broken and require repair by a service center. The motor may also be defective.
E
elaine22Aug 5, 2025
Why is my Parkside PAHE 20-Li B2 Pole Saw having a bad cutting output?
- D
  David PerryAug 5, 2025
  A bad cutting output from your Parkside Pole Saw can be due to a dull saw chain. You may need to sharpen or replace the saw chain. This service can be performed at a service center. Also, check the chain tension, as insufficient tension can also lead to poor cutting.
D
Diana FletcherAug 10, 2025
What to do if my Parkside PAHE 20-Li B2 works with interruptions?
- M
  Michelle HayesAug 10, 2025
  If your Parkside Pole Saw works with interruptions, it might be due to an internal loose contact that needs repair by a service center. Another potential cause is a broken on/off switch.
G
Gwendolyn FloresAug 17, 2025
What to do if the chain gets hot and smoke develops while sawing with my Parkside PAHE 20-Li B2?
- D
  Danny SpencerAug 17, 2025
  If the chain on your Parkside Pole Saw gets hot and smoke develops while sawing, and the rail changes color, it's likely due to too little chain oil. Check the oil level and top off the chain oil if necessary. Also, inspect the oil automation and clean the oil drainage duct as needed. If problems persist, arrange for repair by customer service.
B
Bethany GallegosAug 22, 2025
How to fix a Parkside PAHE 20-Li B2 when the chain jumps off?
- T
  Tanya WhiteAug 22, 2025
  If your Parkside Pole Saw is having difficulties running and the chain jumps off, the chain tension is likely insufficient. Check the chain tension and adjust accordingly.