PDBNP 14 A1
GB
│
IE
│
NI
│
11 ■
■ Ensure that the maximum permissible pressure stated on the ma-
chine is not exceeded.
■ Never carry pneumatic machines by the hose.
Before use
NOTE
► The rivet gun may only be operated on cleaned, oil-atomised
compressed air and may not exceed the maximum operating
pressure of 6.3 bar at the appliance. The compressor must be
fitted with a pressure reducer to regulate the working pressure.
► Note that the maximum working pressure may not be exceeded.
An excessive working pressure does not mean increased output;
it merely increases the air consumption and accelerates appli-
ance wear. Always comply with the technical information.
► Wind the sealing tape supplied around all threaded connectors.
Lubrication
NOTE
► Regular lubrication is particularly important to avoid friction and
corrosion damage. We recommend using a suitable special oil
for compressed air appliances (e.g. Liqui Moly compressor oil).
– Lubrication with mist oiler
A mist oiler (not supplied) continuously and optimally
lubricates the appliance as a preparation stage after the
pressure reducer. A mist oiler gives off fine drops of oil into
the air flow and thus guarantees regular lubrication.
– Manual lubrication
If you do not have a mist oiler, lubricate the appliance be-
fore every use or longer work sessions. To do this drip 3–4
drops of special oil for compressed air appliances into the
lubricant opening
.
To Next Page
Loading...
Need help?
General