PDBNP 14 A1
GB
│
IE
│
NI
│
13 ■
♦ Each time you screw in the connecting nipple , first remove the
old sealing tape
from the thread and re-tighten the thread as
described.
♦ Pull the supply hose connector over the quick-release fastener on
the connecting nipple
until it clicks into place.
NOTE
The compressed air source must be equipped with a pressure reduc-
er to ensure that you can regulate the air pressure.
Use
♦ The appliance is ready for use as soon as the pneumatic air flow
has been established.
♦ Screw the pin collector
onto the thread at the back of the
machine.
♦ Determine the suitable rivet size on the basis of the workpieces
used.
♦ Use a suitable tool to drill a hole into the work pieces in the spot
where the rivet
will be located. Make sure the diameter of the
hole corresponds to the determined rivet size.
CAUTION!
► Suitable safety precautions must be taken depending on the size
and nature of the workpieces. Use suitable clamping devices to
prevent the workpieces from slipping.
► In the event of an interruption to the air supply, release the
trigger
immediately.
► Before switching on the machine, make sure the machine tool is
firmly placed on the surface to be processed.
To Next Page
Loading...
Need help?
General