EasyManuals Logo

Parkside PDSLG 20 B1 Translation Of The Original Instructions

Parkside PDSLG 20 B1
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
GB
Correct handling of the
battery charger
Keep the equipment away from

should be supervised in order
to ensure that they do not play
with the equipment.
Before each use, check the
charger, cable and plug and
have them repaired by quali-
ed professionals and only with
original parts. Do not use a
defective charger and do not

that the safety of the device is
maintained.
Connect the charger only to a
socket with an earth. Ensure that
the mains voltage matches the
specications on the charger rat-
ing plate. Risk of electric shock.
Disconnect the charger from the
mains before closing or open-
ing connection to the battery/
power tool/device.
Keep the charger clean and
away from wet and rain. Do
not use the charger outdoors.
Dirt and the entry of water in-
crease the risk of electric shock.
The charger may only be
used with the corresponding
rechargeable batteries of the
(Parkside) X 20 V Team series.


Avoid mechanical damage to
the charger. 
internal short circuits.
Do not operate the charger on a
combustible surface (e.g. paper,
textiles). -
ing during charging.
Charge the batteries only in
chargers that are recommended
by the manufacturer.
if a charger that is suitable for a

with other batteries.
If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
ed person in order to prevent
hazards.
Do not use the charger to
charge non-rechargeable bat-

damaged.
Charging Process
Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charger,
check that the battery‘s outer
surface is clean and dry.
There is a risk of injury due
to electric shock.
 
of use.
If the operating time is considerably
shortened despite charging, this shows
that the rechargeable battery is deple-
ted and must be replaced. Only use an
original replacement battery purchased

Table of Contents

Other manuals for Parkside PDSLG 20 B1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Parkside PDSLG 20 B1 and is the answer not in the manual?

Parkside PDSLG 20 B1 Specifications

General IconGeneral
BrandParkside
ModelPDSLG 20 B1
CategoryBattery Charger
LanguageEnglish

Related product manuals