PDSSA 20-Li A1
GB
│
IE
│
NI
│
CY │ 7■
Checking the battery charge level
♦ Press the battery charge level button to check
the status of the battery (see also main diagram).
The status/remaining charge will be shown on
the battery display LED
as follows:
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on:
♦ To start the appliance, press the ON/OFF
switch
and keep it pressed in.
The LED work light lights up when the ON/
OFF switch is depressed lightly or fully. This
allows for illumination of the work area in low
lighting.
Switching off:
♦ Release the ON/OFF switch
to switch off the
appliance.
Setting the speed/tightening torque
♦ Press the ON/OFF switch lightly for a low
speed/tightening torque. Increasing the pressure
increases the speed/tightening torque.
■ The tightening torque depends on the selected
speed and impact duration.
CAUTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!
NOTE
► The integrated motor brake ensures rapid
stoppage.
Changing the direction of rotation
♦ Change the direction of rotation by pressing the
rotational direction switch towards the left
or right.
Inserting the bits
♦ Insert the adapter or bit holder into the
tool holder
.
♦ To do this, pull the locking sleeve
forwards
and allow the adapter or bit holder to
engage.
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance-free.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Never allow liquids to get into the appliance.
■ Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
To Next Page
Loading...
Need help?
General
