PDT 40 H6
GB
│
IE
│
3 ■
Technical specifications
Dimensions 245 x 237 x 58 mm
(W x H x D)
Weight (without fasteners) approx. 1,251 g
Maximum permissible
pressure 8bar
Minimum permissible
pressure 4 bar
Recommended pressure
range 4 to 7 bar
Air consumption per
nailing action approx. 0.09 l per
nailing action
Recommended lubricant Pneumatic tool oil
Loading capacity 100 pcs.
Nail lengths 15, 25, 40, 50 mm
Staple lengths 16, 25, 40 mm
Staple width 5.7 mm
Recommended hose
diameter Ø 9 mm
Compressed air quality filtered, atomised oil
and condensate free
Noise and vibration data
Measurement values determined in accordance
with EN 12549:1999, EN ISO 4871. The A-rated
sound pressure level of the tool is typically:
Sound pressure level L
pA
= 82.4 dB (A)
Uncertainty K
pA
= 2.5 dB (A)
Sound power level L
WA
= 95.4 dB (A)
Uncertainty K
WA
= 2.5 dB (A)
These values are tool-specific indicators and do
not reflect the noise development at the place of
usage. Among other things, the noise development
at the place of usage depends on the working
environment, the workpiece, the workpiece rest,
and the number of nailing processes. If necessary,
carry out corresponding noise reduction measures
relative to the workpiece construction and work-
place conditions, e.g. by placing the workpiece
on a noise-dampening underlay, by clamping or
covering the workpiece to reduce the vibration, or by
setting the correct working pressure. In special cases,
personal protective equipment should be worn.
Wear hearing protection!
Vibration emission value
Total vibration value calculated according to
ISO 8662-11:1999: a
h,W
= 1.43 m/s
2
Uncertainty K = 0.41 m/s
2
Mechanical impacts (vibration)
The vibration parameter for the nail and staple
gun has been calculated according to ISO 8662-
11:1999 – hand-held motor-driven machines –
measurement of mechanical vibrations on the
handle – staple guns (see technical specifications).
The value is a tool-specific indicator and does not
represent the effect on the hand-arm system while
using the tool. The effect on the hand-arm system
when you are using the tool depends on factors
such as the gripping force, the applied pressure,
the working direction, the set air pressure, the
workpiece, and the workpiece rest.
General safety instructions
WARNING!
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result
in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
■ Keep your fingers away from the trigger when
you are not using this tool and when you are
changing from one working position to another.
■ Multiple hazards. Read and understand the
safety instructions before connecting, disconnect-
ing, charging, using or servicing the tool, chang-
ing accessories or working near the tool. Failure
to do so may result in serious physical injury.
■ Keep all parts of the body, such as hands, legs,
etc., away from the direction of the shot and
make sure that the fastener cannot penetrate
parts of the body.
■ When you are using the tool, be aware that the
fastener could bounce off and cause injury.
■ Always grip the tool firmly and prepare for recoil.
■ Only technically trained users should use the
nail and staple gun.
To Next Page
Loading...
Need help?
General