Parkside PDUW 280 A1 User Manual (English)

Questions and Answers:

C
Charlene WilliamsAug 4, 2025
Why does my Parkside PDUW 280 A1 compressed air device not start?
- N
  Nicholas RamirezAug 4, 2025
  If your Parkside Tools compressed air device doesn't start or lacks power, it could be due to several reasons. A possible cause is a jammed piston (rusted) in the housing due to a lack of oil. To resolve this, try pressing the piston back with a striking bolt through the tool receiver and introduce a little oil into the connection hose and the tool receiver, then briefly run the device without a tool. Another reason may be that dirt has penetrated via the air hose, or too much lubricating oil or water is in the striking mechanism, in that case you should briefly run the device without a tool. Alternatively, the output power of the air source may be too low, so try using an air source with a higher output power.
S
Scott MartinAug 12, 2025
What to do if the tool doesn't lock into my Parkside PDUW 280 A1?
- C
  Charles JohnsonAug 12, 2025
  If the tool no longer latches into the tool receiver or doesn't lock into place on your Parkside Tools, it may be that the tool or tool receiver is worn out. In this case, a specialist workshop should carry out the repair.
H
Hannah BeckAug 19, 2025
What to do if my Parkside Tools device runs continuously?
- D
  davidmartinezSep 12, 2025
  If your Parkside Tools device operates continuously without the trigger lever being actuated, the valve may be defective. In this case, a specialist workshop should carry out the repair.
X
xsmithAug 27, 2025
How to remove a stuck tool from Parkside PDUW 280 A1?
- R
  robin03Aug 27, 2025
  If you cannot insert or remove a tool from your Parkside Tools, dirt in the sliding sleeve may be preventing unlocking. In this case, a specialist workshop should carry out the repair.

Parkside PDUW 280 A1 Specifications

General

Power	280 W
Voltage	230 V
Frequency	50 Hz
Weight	1.3 kg
No-load speed	15000-21000 rpm
Protection class	II
Protection type	IP20
Oscillation angle	3.2°
Oscillation rate	15000 - 21000 oscillations/min