PEXS 270 C3
■ 6
│
GB
│
IE
│
NI
Before use
Selecting a sanding sheet
Removal and surface
The material removal rate and surface quality are
determined by the grain strength of the sanding
sheet.
■ Please note that you need to use sandpapers
with different grains for working different
materials.
Changing sanding sheets
The random orbital sander has a Velcro sheet that
enables fast and simple changing of the sanding
sheets.
♦ Life the sanding sheet4 on one side and pull
it off the sanding pad3 to remove it.
NOTE
► Before fitting a new sanding sheet4, remove
any dust and dirt from the sanding pad3.
♦ Make sure that the holes on the sanding sheet4
match up with the holes on the sanding pad3.
Dust/chip extraction
■ Please refer to the section entitled "Safety
information".
Dust extraction unit with dust collecting
device
♦ Push the dust collector2 fully onto the appliance.
♦ To empty the dust collector2, pull it off the
appliance.
NOTE
► To ensure optimum extraction, empty the
dust collector2 regularly and tap it out.
To do this, open the dust collector2 by
pressing on the catch8 and pulling off
the rear part. Now remove the dust bag.
External extraction
Connecting
♦ To remove dust using a vacuum cleaner, push
the suction hose of a suitable dust extraction
device (e.g. a workshop vacuum cleaner) onto
the exhaust nozzle6.
NOTE
► If necessary, use the adapter7 by pushing it
into the exhaust nozzle6.
Removal
♦ Pull the hose of the vacuum cleaner off the
exhaust nozzle6 or the adapter7.
Use
Switching on and off
NOTE
► Always switch on the random orbital sander
before making contact with the material, then
apply it to the workpiece. During operation,
you can choose between instantaneous and
continuous operation
Switching on
♦ Press the ON/OFF switch1.
Switching off
♦ Release the ON/OFF switch1.
Speed preselection
♦ Select the required speed with the speed
control5.
Level 1: low speed
Level 6: high speed
To Next Page
Loading...
Need help?
General