Parkside PGHSA 12 A1 User Manual

15
IEGB NI
Never operate the device without
the front cut protection. Risk of in-
jury!
Switching on
1. Place the battery (14) into the device
(see “Inserting/removing the recharge-
able battery”).
2. Check the load status of the recharge-
able battery before starting.
3. Hold the device fi rmly with both hands,
with your right hand on the handle
(5) and left hand on the grip (2). Your
thumb and fi ngers must tightly clasp the
handle (5). Never use the device one-
handed. Risk of injury!
4. To turn on, press the switch lock (3)
with your thumb or index fi nger and
then press the on/off switch (4); the
device will run at maximum speed. Re-
lease the switch lock (3).
5. The device will switch off again when
you release the on/off switch (4). The
device cannot be switched to continu-
ous operation.
Battery charge level
indicator
The charge level of the batteries is indi-
cated by illumination of the corresponding
LED lights of the battery charge level indi-
cator during operation.
3 LEDs illuminated (red, orange and green):
Batteries charged
2 LEDs illuminated (red and orange):
Batteries partially charged
1 LED illuminated (red):
Batteries need to be charged
Switch off the device and remove
the battery before carrying out any
maintenance work.
1. Loosen the mounting screw (10)
of the sprocket cover (9)
(
).
2. To tension the saw chain, turn
the screw (8) for the chain quick-
tensioning system in the direction
.
To loosen the tension, turn the
screw (8) for the quick-tensioning
system in the direction
.
3. Tighten the mounting screw (10)
of the sprocket cover (9) again
(
).
The chain tension of a new saw
chain must be readjusted after a
maximum of 5 cuts.
Removing/inserting the
rechargeable battery
1. To insert the batteries (14) into the de-
vice, push the batteries along the guide
rails into the device. You will hear
them click into place.
2. To remove the batteries (14) from the
device, press the release button
(
14a) on the batteries and pull the
batteries out.
Operating
Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled.
Make sure you have a secure
stance. Before starting, ensure that
the electric chainsaw is in contact
with no objects.

Parkside PGHSA 12 A1 Specifications

General

Brand	Parkside
Model	PGHSA 12 A1
Category	Cordless Saw
Language	English