What to do if Parkside Pressure Washer is not operating?
If your Parkside Pressure Washer isn't working, there might be a few reasons. First, check if the ON/OFF switch is properly turned on. Second, inspect the power supply cable for any damage; if damaged, have it replaced by a qualified electrician. Lastly, make sure your electrical system matches the rating plate data to rule out any mains fault.
Why is my Parkside PHD 110 D1 Pressure Washer not generating any pressure?
If your Parkside Pressure Washer isn't generating pressure, it could be due to air trapped inside. Try turning on the washer with the high-pressure hose attached until bubble-free water flows out of the high-pressure connection. Also, check the water mains pressure to ensure there isn't a drop in pressure.
Provides essential safety guidelines for operating the pressure washer.
Covers essential practices for safe operation, including handling and personal protection.
Details safety requirements for power supply cables and extension cords.
Instructions for initial setup, water connection, and bleeding air from the system.
Instructions on how to clean the pressure washer and its components.
General| Max. pressure | 110 bar |
|---|---|
| Weight | 4.5 kg |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Hose Length | 5 m |
To Next Page