To Next Page

To Previous Page

GB/IE/NI/CY/MT6

TWIN CYLINDER AIR COMPRESSOR - PKOD 5010 A1

1. Introduction

Congratulations on the purchase of your new device. You have thus chosen a high-quality product. The manual is part of this product. It contains important in-

structions for safety, use and disposal. Familiarise yourself with all operating and safety instructions before using the product. Only use the product as described

and for the specified areas of application. Hand over all documents when passing the product on to third parties.

1.1 Intended use

The compressor is used to operate pneumatic tools in the home workshop. It is designed to draw in and compress clean, dust-free, dry and uncontaminated am-

bient air. The ambient air must not contain any aggressive or flammable admixtures. The compressor may only be used in closed spaces with sufficient ventilation.

Pneumatic tools can be connected to the compressor and used for blowing, screwing, tacking and varnishing. This compressor is also suitable for devices with

higher power requirements such as compressed air impact wrenches or compressed air chisel hammers. Read the relevant manual for the correct use of these

pneumatic tools. The compressor and the connected pneumatic tools may only be operated by a trained person. For persons with limited physical, sensory or

mental abilities as well as children and adolescents, operating the compressor and connected pneumatic tools is prohibited. Intended use also includes compli-

ance with all the information in this manual.

Any other use or modification of the products is considered improper and involves considerable risk of accidents. We accept no liability for damage resulting

from improper use. The products are intended for private use only and may not be used commercially or industrially.

1.2 Scope of delivery

1 Compressor

2x Wheel

2x Support stand

2x Air filter

Assembly material:

2x Flange nut

2x Nut

2x Phillips screw

2x Washer

2x Hexagon head screws