What to do if my Parkside POF 1200 B2 does not start?
If your Parkside Power Tool doesn't start, check the socket, power cable, line, and power plug. If necessary, have repairs carried out by a qualified electrician. Also, check the main circuit breaker. If the on/off switch is broken, get it repaired by Customer Care. Note that a faulty motor may also cause this issue.
Why is my Parkside POF 1200 B2 Power Tool engine slower and stops?
Your Parkside Power Tool engine might be slowing down or stopping because the device is overloaded by the workpiece. Reduce the pressure. Alternatively, increase the rotation speed. Also, the workpiece may be unsuitable.
What to do if the milled workpiece has burn marks with my Parkside POF 1200 B2?
If the milled workpiece has burn marks, the rotation speed may be too low, so increase it. The cutter might be unsuitable or blunt; in this case, change the cutter. Also, if the cutting depth is set too large, use the step stop to mill in multiple steps.
Why is dust not being sucked off when using my Parkside Power Tool?
If dust is not being sucked off, ensure the vacuum is switched on before milling. Also, check if the suction hose or suction adapter is clogged and remove any blockages.
What to do if the fringes of the milled part tear off when using my Parkside POF 1200 B2 Power Tool?
If the fringes of the milled part tear off, and there are grooves and uneven parts in the milling, the cutter may be worn out and dull, or the cutter blades may be damaged. In either case, change the cutter.
How to fix a milling that is not straight with my Parkside Power Tool?
If the milling is not straight, the guide bars of the parallel stop may not be mounted firmly. Retighten the screws of the guide bars if necessary.
How to fix a Parkside Power Tool that won't start?
If your Parkside Power Tool doesn't start, check the socket, power cable, line, and power plug. If necessary, have a qualified electrician perform repairs. Also, inspect the main circuit breaker and the on/off switch. A faulty motor can also cause this issue.
Why does my Parkside Power Tool leave burn marks on the workpiece?
Burn marks on the milled workpiece can occur if the rotation speed is too low, so try increasing it. The issue could also stem from using an unsuitable or blunt cutter, in which case you should change the cutter. If the cutting depth is set too large, use the step stop to mill in multiple steps.
What to do if my Parkside Power Tool engine is slower and stops?
If the engine of your Parkside Power Tool slows down or stops, it might be overloaded by the workpiece; reduce the pressure. Also, increasing the rotation speed may solve the problem. The workpiece itself might be unsuitable for the tool.
Why is dust not being sucked off by my Parkside Power Tool?
If dust isn't being sucked off, ensure the vacuum is switched on before milling. Also, check for clogs in the suction hose or suction adapter and remove any blockages.
General| Brand | Parkside |
|---|---|
| Model | POF 1200 B2 |
| Category | Power Tool |
| Language | English |
To Next Page
