Parkside PSHL 2 A2 User Manual (English)

Other manuals for Parkside PSHL 2 A2

Operation And Safety Notes Translation Of The Original Instructions49 pages

Questions and Answers:

R
Robert HarperAug 3, 2025
Why is the visibility poor with my Parkside PSHL 2 A2 welding helmet?
- J
  jonesaaronAug 3, 2025
  Poor visibility with your Parkside Motorcycle Accessories welding helmet can stem from a few issues. First, check if the protector or protective screen is dirty and clean them. Also, ensure you've removed the protective film from the protective screen. Insufficient ambient light can also be a factor, so try increasing the light in your workspace. Finally, verify that you've set the correct darkening shade and reset it if necessary.
K
Kara HaleAug 7, 2025
What to do if my Parkside Motorcycle Accessories welding helmet filter does not darken properly or flickers?
- C
  Christopher KiddAug 7, 2025
  If your Parkside Motorcycle Accessories filter isn't darkening correctly or is flickering, there could be a few reasons. Start by cleaning or replacing the protector. Also, make sure the arc sensor is clean. If the welding current is too low, try setting the sensitivity to the maximum degree.
G
Gregory RobinsonAug 12, 2025
Why is the reaction slow on my Parkside PSHL 2 A2 welding helmet?
- C
  Casey SteinAug 12, 2025
  If your Parkside Motorcycle Accessories helmet's reaction time is slow, it might be due to the ambient temperature being too low or too high. Ensure you're using the helmet within the temperature range of -5 °C to +55 °C. Also, the sensitivity setting might be too low; try increasing it.
C
Courtney FlowersAug 17, 2025
Why does my Parkside PSHL 2 A2 Motorcycle Accessories filter not darken properly or flicker?
- N
  Nancy RiosAug 17, 2025
  If your Parkside Motorcycle Accessories filter isn't darkening correctly or is flickering, it could be due to several reasons: * The protector might be dirty. Try cleaning it or replacing it. * The arc sensor might be obscured. Clean the surface of the arc sensor. * The welding current may be too low. In this case, set the sensitivity to the maximum degree.
K
Kenneth IrwinAug 23, 2025
What to do if visibility is poor with Parkside Motorcycle Accessories?
- L
  Lisa BlairAug 23, 2025
  If you're experiencing poor visibility with your Parkside Motorcycle Accessories, consider the following: * The protector or protective screen might be dirty. Clean both. * The protective film on the screen might not have been removed. Remove it. * The ambient light may be insufficient. Increase the light in your work area. * The darkening shade may be set incorrectly. Reset the darkening shade.
R
Robert BennettAug 27, 2025
Why is the reaction slow with my Parkside PSHL 2 A2 Motorcycle Accessories?
- B
  Brian MorrisAug 27, 2025
  A slow reaction time with your Parkside Motorcycle Accessories could be due to: * Ambient temperature being too low or too high. Ensure you are using the welding helmet in temperatures between -5 °C and +55 °C. * The sensitivity being set too low. Increase the sensitivity setting.