Parkside PTKS 2000 H5

Questions and Answers

J
Justin SkinnerJul 30, 2025
What to do if my Parkside PTKS 2000 H5 engine will not start?
- D
  David CamposJul 30, 2025
  If the Parkside Saw engine won't start, several issues could be the cause. First, check the mains fuse and replace it if necessary. If the fuse is fine, the extension cord might be defective, so try replacing it. If neither of these solutions works, the connections on the motor or switch could be faulty, or the motor or switch itself might be defective. In these cases, it's best to have an electrical specialist handle the repairs.
E
Edward ColonAug 6, 2025
Why does my Parkside Saw leave fire marks on the cutting surface?
- B
  bkelleyAug 7, 2025
  If you notice fire marks on the cutting surface when using your Parkside Saw, it's likely due to a blunt or incorrect saw blade. Try sharpening the blade or replacing it with a new one. If the blade is not the correct type for the material you are cutting, change the saw blade to the appropriate type.
R
Roger FoxAug 14, 2025
What to do if Parkside PTKS 2000 H5 Saw motor will not work, but the fuse is active?
- D
  Derek JohnsonAug 14, 2025
  If the Parkside Saw motor won't work but the fuse is still active, it could be due to a couple of reasons. One possibility is that the cross-section of the extension cable is insufficient. Refer to the 'Electrical connection' section for guidance. Another reason might be that the saw blade is blunt, causing an overload. Try changing the saw blade.
A
andrewfieldsAug 21, 2025
Why is the Parkside PTKS 2000 H5 motor rotating in the wrong direction?
- C
  Christopher MullinsAug 21, 2025
  If the Parkside Saw motor is rotating in the wrong direction, the capacitor is likely faulty. You should have it repaired by an electrical specialist.

Summary

Introduction

Safety Instructions - General

Symbols, Icons, and General Power Tool Safety

Explains safety symbols and outlines general safety rules for power tools.

Safety Information for Table Saws

Laser, Battery, and Table Saw Specific Safety

Details safety for laser, batteries, and specific table saw operations.

Safe Usage Practices

Sawing Procedures and Safety

Saw Blade, Riving Knife, and Sawing Safety

Safe practices for blades, riving knife, and general sawing procedures.

Kickback Prevention and Safety

Explains kickback causes and measures to avoid it.

Circular Table Saw Operation Safety

Assembly Details

Saw Blade Replacement

Detailed steps for replacing the saw blade.

Specific Cutting Operations

Narrow and Very Narrow Piece Cutting

Techniques for safely cutting narrow workpieces using push aids.

Cleaning, Maintenance, and Troubleshooting

Troubleshooting Common Issues

A table listing common problems and their corrections.

Parkside PTKS 2000 H5 Specifications

General

Power	2000 W
No-load speed	5000 rpm
Cutting depth at 0°	85 mm
Cutting depth at 45°	60 mm
Saw blade teeth	24
Max cutting depth at 90°	85 mm
Max cutting depth at 45°	60 mm
Cutting angle	0° - 45°
Saw blade diameter	254 mm
Cutting speed	66 m/s