What to do if my Parkside Saw engine will not start?
If your Parkside Saw engine won't start, there are several potential causes: * A blown mains fuse: Check the mains fuse and replace if necessary. * A defective extension cable: Replace the extension cord. * Disrupted connections on the motor or switch, or a faulty motor or switch: In these cases, it's best to seek repair by a qualified electrical specialist.
Why does my Parkside Saw leave fire marks on the cutting surface?
Fire marks on the cutting surface when using your Parkside Saw can be due to: * A blunt saw blade: Sharpen or change the saw blade. * Using the wrong saw blade: Change to the correct saw blade for the material you are cutting.
What to do if my Parkside PTK 2000 E3 motor will not work, but the fuse is active?
If your Parkside Saw motor isn't working despite the fuse being active, it could be due to: * The cross-section of the extension cable is insufficient. Please refer to the section on 'Electrical connection'. * Overload caused by a blunt saw blade: Change the saw blade.
Why is my Parkside PTK 2000 E3 motor rotating in the wrong direction?
If the motor of your Parkside Saw is rotating in the wrong direction, the capacitor may be faulty. Seek repair by a qualified electrical specialist.
How to fix Parkside PTK 2000 E3 blade dissolving after switching off the engine?
If the blade of your Parkside Saw dissolves after switching off the engine, it may be due to a slightly tightened fastening nut. Tighten the right hand thread nut to resolve this.
Procedure for setting the desired cutting depth using the crank handle.
Guidance on using the parallel stop for various cutting operations.
General| Power | 2000 W |
|---|---|
| No-load speed | 5000 rpm |
| Blade diameter | 254 mm |
| Cutting angle | 0° - 45° |
| Laser class | Class 2 |
| Protection class | II |
| Saw blade | 30 mm |
To Next Page