To Next PageTo Next PageWhy won't my Parkside Water Pump start?
Your Parkside Water Pump might not be starting due to a couple of reasons. First, check if the mains voltage is applied. Second, the float switch might not be working; try moving the float switch to a higher position.
What to do if Parkside PTPS 1100 A1 switches off after a short period?
If your Parkside Water Pump shuts off quickly, it could be due to severe water pollution causing the motor contactor to disconnect the pump. In this case, pull out the power plug and clean both the pump and the shaft. Another reason might be that the water temperature is too high, which also causes the motor contactor to break. Be mindful of the maximum water temperature of 35 °C!
Why is the flow rate insufficient in my Parkside PTPS 1100 A1 Water Pump?
An insufficient flow rate in your Parkside Water Pump can be attributed to severely contaminated water or the presence of substances in the water that create a grinding effect, both of which reduce the pump's performance. To resolve this, clean the pump and replace any worn parts.
What to do if Parkside PTPS 1100 A1 has no discharge?
If your Parkside Water Pump isn't discharging water, it could be due to a buckled pressure hose. Check the hose and repair any bent or damaged sections. Another possible cause is trapped air in the pump casing. To fix this, tip the pump underwater until the air escapes.
How to fix a Parkside PTPS 1100 A1 that does not switch off?
If your Parkside Water Pump isn't switching off, the float switch might be stuck. Ensure that the pump is set up correctly on the pit base so that the float switch can drop freely.
General| Brand | Parkside |
|---|---|
| Model | PTPS 1100 A1 |
| Category | Water Pump |
| Language | English |
Important safety rules for operating the submersible pump.
General safety regulations and precautions for working with the equipment.
Safety measures related to electrical connections and shock prevention.
Guidance on how to correctly position or hang the pump.
Details on how to connect the pump to the power supply.
Instructions for attaching the hose or pipeline to the pump outlet.
