Why does my Parkside PWSAP 20-Li A1 suddenly stop?
Your Parkside Grinder might suddenly stop because it is overloaded, the battery pack is discharged, or the battery pack is too hot. To resolve this, remove the product from the workpiece and switch it on again. Alternatively, remove and charge the battery pack, or remove the battery pack and let it cool down.
What to do if my Parkside Grinder does not start?
If your Parkside Grinder does not start, it could be due to several reasons: the battery pack might not be properly attached (attach properly), the battery pack might be discharged (remove and charge the battery pack), or the battery pack might be damaged or there is another electrical defect to the product (check by a specialist electrician).
Why is there excessive vibration or noise coming from my Parkside Grinder?
Excessive vibration or noise from your Parkside Grinder could be due to a dull or damaged accessory (replace with a new one) or loose bolts/nuts (tighten bolts/nuts).
Why is the Parkside PWSAP 20-Li A1 Grinder not reaching full power?
If your Parkside Grinder is not reaching full power, it is likely that the air vents are blocked. Clean the air vents to resolve this issue.
What to do if my Parkside Grinder gives an unsatisfactory result?
If your Parkside Grinder provides an unsatisfactory result, it may be because the accessory is worn (replace with a new one) or the accessory is not suitable for the intended operation (use a suitable accessory).
Covers safety aspects related to the work environment, electrical precautions, and user protection.
Instructions on proper usage, maintenance, and handling of power tools.
Specific safety instructions pertinent to angle grinder operations.
Guidance on understanding and preventing kickback during grinder operation.
Specific safety precautions to be taken during grinding operations.
Safety guidelines for performing wire brushing tasks with the tool.
Instructions on how to act in case of malfunctions or emergencies.
Identifies potential risks that remain even when operating correctly.
Procedures for starting, stopping, and performing an initial test run.
Instructions for performing grinding and wire brushing tasks.
General| Battery Voltage | 20 V |
|---|---|
| Disc Diameter | 125 mm |
| Spindle Lock | Yes |
| Battery Type | Lithium-Ion |
| Spindle Thread | M14 |
| Weight | Approx. 1.5 kg (without battery) |
To Next Page