components when starting or operating the r.
he procedure is as follows:
1.
1. Start-in-gear protection rod
moto
T
Remove the top cowling.
2. Remove the start-in-gear protection rod.
1
3. Remove the starter cover after removing olts. the three b
4. Prepare the engine for starting. For further information, see section 2.5.
5. Insert the knotted end of the emergency starter rope into the notch in the fl
rope several turns around the flywheel clockwise.
ywheel rotor and wind the
43
To Next Page
Loading...
Need help?
General
