Need help?Do you have a question about the Partflow MRC 500 and is the answer not in the manual?
Process values for each pen can be displayed on the LED display or blanked.
Instrument provides relay control outputs programmable for on-off control capability.
Two optional alarm output relays with SPDT contacts available for each pen.
Optional RS-485 digital communications port available using MODBUS RTU protocol.
Standard recorder operates on 90-264 VAC; low voltage option available.
Instructions for removing the recorder from its carton and inspecting for damage.
Guidance on selecting a suitable location and mounting the instrument securely.
Guidelines to minimize electrical noise interference during wiring.
Details on making electrical connections to terminal blocks for various functions.
Procedure for changing the chart paper and positioning the pens.
Configuration of single and dual output control modes like Heat/Cool.
How to review and modify alarm setpoints for process alarms.
Explanation of high/low limit alarms, their latching behavior and acknowledgment.
How to use jumpers JU1 and JU2 to select input types for Pen 1 and Pen 2.
Steps to enter Program mode for setting chart speed, input types, scaling, etc.
Procedures for running display, keypad, relay, and chart tests.
Calibration of input types like Thermocouple, RTD, mV, mA, and V.
Calibrating pens to the chart for span and arc adjustments.
General| Brand | Partflow |
|---|---|
| Model | MRC 500 |
| Category | Controller |
| Language | English |
To Next Page