ENGLISH
3
Symbols 2
Important! Read before using chain saw 2
Contents 3
EC declaration of conformity 3
Technical specifi cations 4
Chain saw parts 5
Safe use 5
Starting and stopping 7
Daily inspection and maintenance 7
Kickback prevention 8
Chain brake with kickback guard 9
- Kickback guard inspection 9
- Manual chain brake function check 9
- Inertia chain brake function check 9
Mounting guide bar and adjusting chain 10
Chain catcher 11
Right hand guard 11
CONTENTS
Slip clutch 11
Electronic overload protection 1950W 11
Cutting equipment 11
Chain and guide bar lubrication 12
- Chain oil 12
- Filling chain oil 12
- Checking automatic 12
chain lubrication system
- Checking chain wear 12
Filing chain 13
Limbing 13
Crosscutting 14
Felling operations 14
- Danger zone 15
- Felling direction 15
- Clearing branches/Line of retreat 15
- Felling 15
Husqvarna Norge AS, N-1708 Sarpsborg, Norway hereby declares that the following chain saws:
Partner 1750 and Partner 1950, with serial numbers starting at 54000001 and onwards,
- are manufactured in compliance with EC Directive 98/37/EC (Machinery), EC Directive 73/23/EEC including amendments
(Low Voltage Directive), EC Directive 89/336/EEC including amendments (Electromagnetic Compatibility Directive), and in
accordance with annex V of Directive 2000/14/EC (Noise Emission in the environment by equipment for use outdoors)
- are manufactured in compliance with the following harmonized standards: EN 50144-1, EN 50144-2-13, IEC 60745-1
and IEC 60745-2-13.
Notifi ed body: 0404, SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has:
- carried out the EC type examination in accordance with the machinery Directive (98/37/EC) Article 8(2)(c)
- issued EC type examination certifi cates No. 404/04/1038 - Partner 1750 and 404/04/1037 - Partner 1950 pursuant to
machinery Directive 98/37/EC, Annex IV (4)
The chain saw submitted is identical to the samples submitted for EC type examination.
The measured and guaranteed sound power levels in accordance with Directive 2000/14/EC are set forth under Technical Data
in the User’s Manual.
Sarpsborg, 1th of October 2005
--------------------
Jan Hansen, President
EC DECLARATION OF CONFORMITY
To Next Page
Loading...
