-- 7 --
NOTE:
Unit must be placed on its side when
a dding fu el (s ee illustrat ion below).
STOPPING YOUR ENGINE
D
To stop the engine, move the throttle lever
to the STOP position.
BEFORE STARTING THE ENGINE
W ARNING:
YouMUSTmakesurethe
tubes are secure before using the unit.
D
Fuel engine. Move at least 3 meters away
from the fueling site.
D
Hold the unit in the starting position as
shown. Make sure the blower end is di-
rected away from people, animals, glass,
and solid objects.
Blower
Vacuum
STARTING POSITION
W ARNING:
When starting engine,
hold the unit as illustrated. Do not set unit on
any surface except a clean, hard area when
startingengineor while engineis running.De-
bris such as gravel, sand, dust, grass, etc.
could be picked up by the air intake and
thrown out through the discharge opening,
damagingtheunit or property,or causing seri-
ous injury to bystanders or the operator.
ST ARTING A COLD ENGINE (or a
warm engine af ter running out of fuel)
1. Move throttle lever to the position.
2. Move choke lever to the FULL CHOKE
position.
3. Slowly press the primer bulb 8 times.
Throttle Lever
Choke Lever
Primer Button
4. Pull starter rope sharply until engine at-
tempts torun,but no morethan5 pulls (be-
low 0
_
C, 8 pulls).
NOTE:
If engine attempts to start beforethe
5
th
pull, go to next step immediately .
5. Move the choke lever to the HALF
CHOKE position.
6. Pull the starter rope sharply until the en-
gine runs, but no more than 5 pulls (below
0
_
C, 10 pulls).
7. Run engine for 5 seconds, then move
choke lever to the RUN position.
8. Allow the unit to run for 30 more seconds
at the RUN position before moving the
throttle lever to the
position.
Ifengine has notstartedafter5pulls (atHALF
CHOKE), repeat ST ARTING A COLD EN-
GINE procedure.If engine still does not start,
proceed to STARTING A FLOODED EN-
GINE.
9. To stop the engine, move the throttle lever
to the STOP position.
STARTING A WARM ENGINE
1. Move throttle lever to the position.
2. Pull starter rope sharply until engine runs
but no more than 5 pulls.
NOTE:
If engine has not started, pull starter
rope 5 more pulls. If engine still does not run,
it is probably flooded.
3. To stop the engine, move the throttle lever
to the STOP position.
STARTING A FLOODED ENGINE
Flooded engines can be started by placing
the choke lever in the RUN position. Move
throttle lever to the fast position
; then,
pull rope until engine starts. After engine
starts, movethe throttlelever tothe slowposi-
tion
to allow engine to idle.
St arting cou ld require pu lling the star te r ro pe
many times depending on how badly the unit is
flooded.
If unit still doesn’t start, refer to the TROUBLE-
SHOOTING T ABLE or conta ct an authorized
se rvice d eale r.
To Next Page
Loading...
