Need help?Do you have a question about the Pasquali VANTH 6.40 and is the answer not in the manual?
General safety guidelines including prudence, training, manual reading, and decals.
Guidelines on appropriate clothing for operating the tractor and performing maintenance.
Warning against operating the tractor if physical condition is not suitable.
Instruction not to change the engine's injection system for higher RPM.
Warning against changing pressure relief valve settings on hydraulic circuits.
Guidance on operating with a safety roll bar and checking its integrity.
Recommendation to keep a first aid box on the tractor.
Overview of the tractor's instrument panel and its components.
Operation of turn signals and the corresponding indicator light.
Signal light indicating engine pre-combustion chamber heating.
Indicator light for parking and low beam lights.
Indicator light for high beam headlights.
Functions of the ignition switch in different positions.
Operation of the hazard lights and its indicator.
Indicator light for low fuel level.
Indicator light for insufficient battery charging.
Display for tractor working hours and engine RPM.
Indicator for excessive engine temperature.
Indicator light for insufficient engine oil pressure.
Operation of the power steering acting on the articulating joint or wheels.
Using the hand throttle for constant engine RPM during work.
Operation of the service brakes by depressing the pedal.
Function of the accelerator pedal to increase engine RPM.
Operation of the parking and emergency brake.
Operation of the rear differential lock pedal.
Operation of the front differential lock lever.
Procedure for locking and releasing the front differential.
Selecting different PTO operating modes: Neutral, Unified, Synchronized.
Control of the lift linkage position from raised to lowered.
Controlling single-acting cylinders connected to quick couplings.
Checking and topping up engine oil level.
Ensuring sufficient fuel level for the planned work.
Ensuring the PTO splined shaft is covered with its guard.
Verifying parking brake is engaged when tractor is stopped.
Ensuring all control switches are off before starting.
Verifying gear and range levers are in neutral.
Depressing the clutch pedal fully before starting the engine.
To Next Page
General
