Setup
When launching the BlackBox for the first time the ‘Setup Wizard’ will guide through
the essential settings ready for guidance and area measurement.
Navigation Bar
N.B. The wizard can be re-accessed via Setup > Unit Setup > Run Initial Setup
Wizard.
Starting a Job
Previous
Next Home Information
Cancel Confirm
Guidance Modes
Straight - Sets a straight guidance line between set point A and point B, which is then
replicated both sides of the original line at equal intervals based on the entered width.
Curved - Creates a curved guidance line based on the path driven between set point A
and point B. The line is then replicated both sides of the original line at equal intervals
based on the entered width.
1) Press Start Job.
2) Enter the Farm/Field
name and Confirm
3) Enter working Width,
then select the Guidance
Mode and press Confirm
to begin job.
N.B. Before starting a job it is important the correct Bluetooth device is selected and
that the GPS Quality level is within the green. This ensures the best GPS
performance for use with guidance and area measurement.
To Next Page
Loading...
