-5-
CHANGING THE FILTERS
1. Loosen the 2 locks that hold the filter board in place.
2. Slide out the filter panel board.
3.
Remove the used filters and replace with new filters.
WARNING
• Always wear approved protective gear when changing the filters.
• Filters should be changed after each remediation job.
•
If the indicator light is on, always change the HE PA/Activated Carbon Filter.
APPLICATIONS
Water Damage
In this application, the air scrubber should be placed in the center of the affected area. The air
scrubber will draw in the air, filter it, then blow out the newly cleaned air. To begin the process.simply
turn on the scrubber and it will start cleaning the air. Keep in mind that if you are working in a large
area or one divided by walls, you may need several air scrubbers to effectively clean the air.
Odor Control
The air scrubber ,when used with the HEPA/Activated Carbon Filter, is excellent at odor control, as
well. Simply place the carbon filter in the pre-filter slot and it will capture a wide variety of odor-causing
gas molecules, such as volatile organic compounds (VOC's), smoke, soot, and paint fumes.
Other Uses
The air scrubber is also useful in many other applications including mold remediation, fire damage,
dust control, and sewage remediation.
WARNING!
Breathing Hazard
When using the air scrubber in a containment area, always turn off power to open combustion
appliances, such as fireplaces, furnaces, water heaters, and HVAC systems, to avoid the risk of
To Next Page
Loading...