EN142 EN 143
Using the tool
1. To switch on the tool, press the on / o
switch3. The more the on / o switch3 is
pressed, the faster the drill driver rotates.
2. Make sure your workpiece can not slip.
Start working while holding the tool firm-
ly.
3. To switch o the tool, release the on / o
switch3.
Warning! If the tool is not in use,
centre the rotation direction switch
in order to lock the tool.
Intended Use
The tool is intended for driving in and loos-
ening screws as well as for drilling in wood,
metal and plastic.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Overload protection
When the load is too high or the allowable
battery temperature is exceeded, the mo-
tor comes to a stop. Relieve the load on the
machine immediately and allow cooling for
approx. 30 seconds at the highest no-load
speed.
Residual risks
Even if you are operating this product in
accordance with all the safety require-
ments, potential risks of injury and dam-
age remain. The following dangers can
arise in connection with the structure and
design of this product:
1. Injuries and damage to property due to
broken application tools.
2. Danger of injury and property damage
caused by flying objects.
Product overview
1 Chuck ring
2 Chuck
3 On / O switch
4 Soft grip
5 Battery
6 Battery release switch
7 Rotation direction switch
8 Torque ring
9 Gear selector
Slide the battery onto the charger and
check its LED:
Red: Charging
Green: Battery is fully charged
Flashing Red: Battery is defective
Flashing Green:
Battery is too hot/ cold
2
CHARGE BATTERY
Plug the charger into a suitable wall
socket.
Caution! Only use the provided
charger to charge the battery.
11 2
1
9
2
3
4
6
5
7
8
Lieferumfang
Etendue de livraison
Materiale compreso nella fornitura
Leveringsomvang
Leveransomfång
Rozsah dodávky
Rozsah dodávky
Volumul livrat
Scope of delivery
DE
SV
IT
SK
FR
CZ
NL
RO
GB
1x
1x1x
1x
To Next Page
Loading...
Need help?
General