ATTENTION!
The thermodisc is set to turn on at approximately 120° F and
will shut off at approximately 90° F.
NOTE: Blower will not start
until thermodisc is heated to approximately 120° F.
The thermodisc has been factory tested.
PayandPack.com
info@payandpack.com
2. Installation Solution 2 for select model fireplacs.
BlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlowerBlotsdVautomatIcthermostatBlower
BlotsdVautomatIcthermostatBlower
Before installing the blower, wire the receptacle into an
electrical circuit. This should be done before framing the
fireplace. Wire with minimum 60° C wire in accordance
with prevailing codes.
Page 3
To Previous Page
