PayandPack Durablow BK User Manual

Model BK, BKT Blower Fan Kit
This is a factory replacement kit. The blowers are aftermarket
models with LIMITED INSTRUCTIONS!
Intended to be installed by a qualified technician.
Installation Precautions
The BK & BKT Blower Kit is tested and safe when installed in accordance with this installation manual.
It is your responsibility to read all instructions before starting installation and to follow these instructions
carefully during installation to ensure maximum benefit from, and safe operation of the fan.
WARNING
Shock Risk / Explosion Risk
- DO NOT wire 110-120 VAC to gas control valve
- DO NOT wire 110-120 VAC to wall switch
• Incorrect wiring will damage millivolt values
• Incorrect wiring will override IPI safety lockout and
may cause explosion
NOTE: This appliance must be electronically wired and
grounded in accordance with local codes, or in the absence of
local codes, with National Electric Code ANSI/NFPA 70-
latest edition or the Canadian Electric Code CSA C22.1
CAUTION
Sharp Edges
• Wear protective gloves and safety glasses during
installation
WARNING: ELECTRICAL GROUNDING INSTRUCTIONS
This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and
should be plugged directly into a properly grounded three-prong receptacle.
MODEL BK
MANUALLY CONTROLLED
BLOWER
MODEL BKT
THERMOSTATICALLY
CONTROLLED BLOWER
GA3650 GA3650B
GA3700 GA3700A
GA3750 GA3750A
GA3650T GA3650TB
GA3700T GA3700TA
(Both blower fits are for Desa, FMI, Vanguard, Vexar, Comfort, Flame Glow, Rotom brands fireplace.)
Page 1
Tools required
Pliers•
Phillips Screwdriver•
Flat Blade Screwdriver•
If any of these pieces are missing or damaged, or if the installation instructions for your re-
place or stove are not included in this manual, contact the dealer where you purchased this
kit or email us on PayandPack.com for referral information.
NOT original parts.
INSTALLATION INSTRUCTIONS
PayandPack.com
info@payandpack.com

PayandPack Durablow BK Specifications

General

Brand	PayandPack
Model	Durablow BK
Category	Blower
Language	English

Summary

Model BK, BKT Blower Fan Kit Installation

Electrical Grounding Instructions

Appliance must be wired and grounded per local codes or NEC/CEC.

Installation Precautions

Read and follow all instructions for safe operation and maximum benefit.

Shock Risk and Explosion Risk Warnings

Warnings against incorrect wiring to gas control valve or wall switch causing damage.

Caution: Sharp Edges

Wear protective gloves and safety glasses during installation.

Removing Louver Panel for Some Models

Removing Louver Panel for Wood, B-Vent, and Vent-Free Models

Instructions for removing panels or stamped face louvers using a flat blade screwdriver.

Removing Louver Panel for Direct-Vent Models

Instructions for removing direct-vent louvers using spring latches or bullet-style clips.

Model BK and BKT Wire Assembly

Model BK Wire Assembly Steps

Steps for attaching power cord, ground wire, and positioning the blower motor.

Model BKT Wire Assembly Steps

Steps for attaching thermal switch bracket, wiring harness, and power cord terminals.

Connecting Power and Operating Blower

Wire and Power Cord Checks

Ensure power cord is clear, wiring is not pinched, and all connections are secure.

Connecting Power and Initial Operation

Turn on power, plug in the cord, and test BK model operation.