CIRCULATING FAN
Compare contents of carton in Figure 1 with actual parts received.
If any parts are missing or damaged, contact your dealer before
starting installation.
Tools required for assembly:
• Large straight blade
• Screwdriver to assist in removing hearth brick
Installation Precautions
To Install Replacement Blower Fan
1. Condition 1:
If your fireplace has glass doors, it is highly recommended that doors and the lower track be
completely removed for easier access.
2. Condition 2:
Remove the hearth brick by carefully lifting it out of the fireplace. Next, remove the access panel
by carefully pulling up and out from the back middle edge of the panel until the tabs at each side
are free. Use caution – the panel edges may be sharp (see Figure 2).
3. Condition 3 :
Remove the two (2) ceramic fiber refractory panels by carefully lifting them out of the fireplace.
For GFK-160 blower fan only (blower kit excluded)
Since there is no speed control, termostat, wire, bolt, nut...etc. components provided,
you have to keep all related original parts/ components to install this blower
and make it be functional with them.
Such as speed control or thermostat sensor.
Fig. 1
INSTALLATION INSTRUCTIONS
PayandPack.com
info@payandpack.com
This is a contractor replacement
blower fan with motor only. The blowers are aftermarket
models, not original equipment with LIMITED INSTRUCTIONS!
Intended to be installed by a qualified technician.
Page 1
To Next Page
Need help?
General
