PBI Dansensor CheckPoint O2/CO2 - Battery Replacement Guide; Replacing Device Batteries; Spare Parts and Accessories; Available Consumables and Parts

PBI-Dansensor A/S COPYRIGHT © PBI-200616-G 03/2010
CheckPoint O
2
/CO
2
EN User Manual 15
Battery replacement
When the CheckPoint using ordinary
batteries shows "Lo./BAt.", the batteries
must be replaced.
1. Unscrew the screw that secures the
battery cover (7) on the left side, and
dismount the cover.
2. Disconnect the connector (13) on the
battery pack.
3. Take out the battery pack, and replace
the batteries with 4 new alkaline
batteries (type AA).
4. Mount the battery pack again (lower/
left connector).
5. Connect the connector to the battery
pack.
6. Mount the cover and screw (be careful
not to squeeze the wire)
Spare parts and accessories
Consumables
200717 Needle pen incl. hose and
fittings
200719 Four alkaline batteries, type AA
200726 Rechargeable battery pack,
type NiMH
220121 Needle kit, 0.5 mm (10 pcs)
280205 Needle kit, 0.5 mm (100 pcs)
240620 0,2µ filter for needle, (3 pcs.)
Spare parts
200616 User manual, CheckPoint
CO
2/
O
2
200720 Pump, complete
200721 Internal hoses with fittings
250722 O
2
sensor
200725 Fittings kit
Optional equipment
200550 AC/DC adapter, European
mains connector (EU)
200703 AC/DC adapter, English mains
connector (GB)
200704 AC/DC adapter, American mains
connector (USA)
200678 Wristlet kit (CheckPoint on arm)
280167 Needle kit, blunt (10 pcs.)