PDC spas Owner's Manual - ProView Control Faults; System Errors and Pump Faults; Maintenance Reminders

Operaon Systems, Premium Series | ProView™ Control
52
The sengs have been reset (Persistent Memory Error)* – M021
Contact your dealer or service organizaon if this message appears on more than one power-up.
The clock has failed* – M020
Contact your dealer or service organizaon.
Configuraon error (Spa will not Start Up)
Contact your dealer or service organizaon.
The GFCI test failed (System Could Not Test the GFCI) – M036
(North America Only) May indicate an unsafe installaon. Contact your dealer or service organizaon.
A pump may be stuck on – M034
Water may be overheated. POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your dealer or service organizaon.
Hot fault – M035
A Pump Appears to have been Stuck ON when spa was last powered. POWER DOWN THE SPA. DO NOT ENTER THE WATER.
Contact your dealer or service organizaon.
Reminders
General maintenance helps.
Reminder Messages can be suppressed by using the Preferences Menu.
Clean the filter
May appear on a regular schedule, i.e. every 30 days. Clean the filter media as instructed by the
manufacturer.
Test the GFCI (or RCD)
May appear on a regular schedule, i.e. every 30 days.
The GFCI or RCD is an important safety device and must be tested on a regular basis to verify its reliability. Every user should be
trained to safely test the GFCI or RCD associated with the hot tub installaon. A GFCI or RCD (European) will have a TEST and RESET
buon on it that allows a user to verify proper funcon.
Change the water
May appear on a regular schedule, i.e. every 90 days. Change the water in the spa on regular basis to maintain proper chemical
balance and sanitary condions.
Change the filter
May appear on a regular schedule, i.e. every 30 days. Filters should be replaced regularly to maintain proper spa funcon and
sanitary condions.