PDP ROCK CANDY - Connecting Your Keyboard; Pairing Your Keyboard

The keyboard USB receiver is already paired with the keyboard at the factory. However, if
you have a replacement USB receiver, you will need to pair it with your keyboard. To pair the
keyboard using the USB receiver, please follow these steps:
1) Ensure that the USB receiver is unplugged.
2) Press and hold the “Esc” key, then press the “=” key. The LED for Low Battery will
temporarily light up solid to indicate pairing mode.
3) Plug the USB receiver into a USB port on your computer.
Use a Philips screwdriver to remove the two
screws from the battery door as shown:
Insert two AAA alkaline (included)
batteries with the polarities as shown:
1 2
ENGLISH
2
Connecting Your Keyboard
AAA
AAA
AAAAAA
Close the battery door and securely
tighten the screws.
Plug the included USB receiver into any
available USB port on your computer.
3 4
Pairing Your Keyboard