PDP Snap Remote - Tips and Usage Information; Snap Remote Usage Tips

5. Place the remote close to the PS4
™
system
and wait for “PDP Snap Remote” to appear
in the device list.
6. Using a connected controller, select “PDP
Snap Remote” from the list, and press the “X”
button. When prompted, select “Yes”.
7. The red LED on the remote will illuminate for
3 seconds and then turn off, indicating
successful pairing.
8. If pairing is unsuccessful, repeat steps 3
through 6.
•
For the latest PS4
™
usage instructions, refer to the
user’s guide for the PS4
™
system
(manuals.playstation.net/document/).
•
For the latest Snap Remote instructions, refer to
the online user’s guide
(support.pdp-eu.com).
•
The PS4
™
system will disconnect the remote
after 30 minutes of inactivity. To reactivate the
remote, press the PS button on it once. The Snap
Remote will then immediately reconnect to the
PS4
™
system for continued use.
•
Only one Snap Remote can be registered with
the PS4
™
system at a time.
•
When you pair the Snap Remote with another
PS4
™
system, registration with the original
PS4
™
system is cleared. To use the remote
with the original PS4
™
system, you will have
to follow the pairing procedure again.
TIPS