To Next Page

To Previous Page

English

1. Using the Pro BFG™ in Wireless Mode:

A. To use the Pro BFG™ in Wireless Mode, start by plugging the included Wireless USB Dongle into

your Xbox Series X|S, Xbox One, or Windows 10/11 PC. The LED on the dongle will begin flashing

purple.

B. To turn the controller on, press the Xbox Button on the front of the Pro BFG.

C. The LED ring around the controller’s Xbox button and the LED light on the dongle will be solid

purple to indicate the two are paired.

D. To turn off the controller, press and hold the Xbox Button for 6 seconds until the purple LED

around the Xbox button turns off.

Note: If the controller becomes unresponsive and cannot be powered off normally, press and hold the

Xbox Button for 12 seconds to force a hard reset.

2. Wireless Pairing Troubleshooting

A. If you encounter an issue pairing the controller, start by plugging in the dongle into the USB port

on your console/PC

B. Use a paperclip or pin to press and hold the internal connect button, located on the side of the

USB dongle, until the LED blinks rapidly.

C. With the Pro BFG controller turned on, press and hold the Profile button on the back of the

controller until the dongle LED and LED ring on the controller’s Xbox button turns solid purple.

3. Using the Pro BFG in Wired Mode:

A. To use the Pro BFG in Wired Mode, plug the included USB-C cable into the USB-C port on the top

of the controller, and the other end into your Xbox Series X|S, Xbox One, or Windows 10/11 PC.

B. To connect to the console or PC, press the Xbox Button on the front of the controller.

Questions and Answers:

Need help?

Do you have a question about the PDP Victrix Pro BFG and is the answer not in the manual?

PDP Victrix Pro BFG Specifications

General