The Pro BFG includes 4 analog stick caps (2 standard concave, 1 short convex, 1 tall Sniper Stick).
A. To remove the analog stick cap, firmly pull up on the analog stick to remove it from the
controller.
B. To install the analog stick cap, align the mounting neck and press down until it clicks securely
into place.
15. Changing the D-pad:
A. To remove a D-pad, hold it between two fingers and gently pull the D-Pad cover off.
B. To add a D-pad, line it up with the controller and gently push down until you hear a click.
16. Changing the Gates:
A. Remove the Module you wish to change the analog stick gate on (follow directions for
Removing/Swapping Modules).
B. To remove a gate, flip the module plate over (so the back is facing you) and press firmly on the
back side of the gate with your thumb; the gate should pop out.
C. When adding a gate, first make sure the front of the module plate is facing you. Then, line up
the small alignment dot on the gate to the alignment dot on the module plate (octagonal gate
only), and press down firmly until it clicks in around the whole gate.
To Next Page
Loading...
