SPECIFICA
TIONS
1.
DC Input Voltage 10.5-15V
2. AC Output Voltage 105-125V
3. AC Receptacle Two 110/120V AC North American
Standard Receptacles
4. Maximum Continuous Power 150W
5. USB Output DC Two 5V/500mA
6. Effi ciency ≥ 85%
7. No Load Current Consumption ≤ 500mA
8. High Input Voltage Limit 15 ± 0.3V (red LED is on)
9. Short Circuit and Reverse Polarity Protection 1 x 15A spade fuse
10. Signal Format/Output Modulated sine wave 60Hz ± 2Hz
11. Working Temperature 50°F to 86°F (10°C to 30°C)
12. Storage Temperature -4°F to 185°F (-20°C to 85°C)
13. Storage Air Humidity 10%-90%
TR
OUBLESHOOTING
Pr
oblem Situation Action
Lo
w output
voltage
In
verter is overloaded Do not exceed maximum load rating for the Inverter.
Input voltage is below
10.5 volts
Increase input voltage above 10.5 volts to maintain
regulation.
No power
output
12-volt cigarette lighter/
accessory socket needs
ignition to be on
Turn ignition to ACC position.
Battery voltage below
10 volts
Recharge or replace battery.
Equipment being
operated draws too
much power
Reduce load; DO NOT exceed maximum rating for the
Inverter.
Inverter in thermal
shutdown condition
Allow Inverter to cool down. Ensure there is adequate
ventilation around the Inverter. Ensure that load is no more
than its maximum rating for continuous operation.
AC output is shorted Check condition of power plug and 12-volt cigarette lighter/
accessory socket. Clean or replace as necessary.
Fuse is blown Check fuse and replace as necessary.
PEAK
CAR BATTERIES
To Previous Page
Loading...