Product instruction manual
A3 Pouch Laminating System
Peak lite - PL320
Peak laminators have been designed to be user
friendly, however we strongly recommend you take
a few minutes to read through this manual to ensure
correct operation.
Keep this manual safe for future reference.
Warranty & Incorrect Use
IMPORTANT INFORMATION
Your laminator should reach you in perfect condition, however please retain all original packaging once you have
unpacked your laminator in case you need to return it to us. If your laminator arrives damaged or faulty in anyway, this
must be reported to your supplier immediately. If you send your laminator back for repair under warranty at any time,
then the warranty may be void if the laminator is not packaged correctly and as a result is damaged in transit. The
laminator you have purchased comes with a 1 year warranty on defective parts. THIS DOES NOT COVER any jams mis-
feeds or wrap arounds caused by operator error and you will be liable for the repair costs (including delivery charges).
Safety!
.
Always remember to switch your pouch laminator o after use. Leaving it on for long periods can cause damage
to the laminator and is a health and safety hazard
.
Always put the sealed end of the pouch into the laminator rst
.
NEVER laminate metal objects such as keys or coins
.
NEVER use the laminator near water and do not leave the laminator next to a hot area such as a radiator
.
Always wrap the power cord around safely after use and do not leave it dangling where it could cause an accident
.
Do not allow children to use the laminator, unless supervised
.
If your laminator stops working, do not try to x it yourself by disassembling the machine. Contact your supplier
for advice
.
Do not operate the laminator if the power cable is damaged in any way
.
Do not use this appliance for anything other than it’s intended purpose
Please note, if you do not follow the safety guidelines above and your laminator breaks, you will not be
covered under warranty.
FAQ’S
My document has come out cloudy - what does this mean?
This means that the temperature setting is not quite hot enough. Try increasing the temperature by 5
o
and try again as applying
more heat should x the problem.
My document has come out wavy - what does this mean?
If the document comes out with a wavy nish the temperature is set too high. Decrease the temperature by 5
o
and try again. If you
have an important document to laminate such as a photograph, it is always good to try a test document rst to ensure you have the
laminator at the perfect temperature.
To Next Page
Need help?
General
