Need help?Do you have a question about the Peak PP330 and is the answer not in the manual?
General| Number of Rollers | 2 |
|---|---|
| Throat Width | 330 mm |
| Warm-up Time | 5 minutes |
| Laminating Speed | 300 mm/min |
| Maximum Laminating Thickness | 250 microns |
| Carrier | No |
| Laminating Width | 330 mm |
Unpack the laminator, place it on a surface, connect the power cable to the device and a power source.
Press the red POWER switch to turn on the laminator and ensure the FWD/REV switch is set to FWD.
Set the HEATER switch to ON and adjust the temperature according to the required setting.
Understand operational guidelines to avoid jams, as user error is not covered by warranty.
Follow safety guidelines regarding power, usage, supervision, and maintenance.
To Next Page
