3
INTRODUCTION
Read and understand this Owner’s Manual before using the Rechargeable LED Work Light. Recharge
and operate the Rechargeable LED Work Light only as described in this Owner’s Manual.
FEATURES
5
1
4
2
3
6
9
7
8
Legend
1. ON/OFF Switch
2. Magnet
3. 30 LED Lights
4. Swivel Hook
5. 12-volt DC Charging Adapter
6. 2-amp Fuse
7. Charging Port
8. Red LED Charging Indicator
9. 110/120-volt AC Charging Adapter
RECHARGEABLE LED WORK LIGHT CHARGING
This Rechargeable LED Work Light is shipped in a partially charged state. BEFORE
fi rst use, charge the Rechargeable LED Work Light battery using the 110/120-volt AC charging
adapter for 6 hours or, if using a 12-volt DC charging adapter, charge for 5 hours. Failure to
follow this procedure may permanently damage the battery.
Charger Features
The 110/120-volt AC charging adapter allows charging from a household wall outlet (110/120 volts
AC). The 110/120-volt AC charging adapter connects to the charging port at the bottom of the
Rechargeable LED Work Light handle.
The 12-volt DC charging adapter allows charging from a 12-volt DC cigarette lighter/accessory
socket. The 12-volt DC charging adapter connects to the charging port at the bottom of the
Rechargeable LED Work Light handle. The 12-volt DC charging adapter contains a 2-amp fuse within
the end of the adapter to prevent damage from excessive current while charging.
A red LED charging indicator is next to the 30 LED lights, and while the Rechargeable LED Work
Light is charging, the red LED charging indicator will be illuminated. When the LED Work Light is fully
charged, the red LED charging indicator will turn off.
Charging Guidelines and Precautions
x Only use the charging adapters that were provided with this Rechargeable LED Work Light. Use
of other chargers or adapters may void any warranty, cause product damage, increase risk of fi re,
and/or result in personal injury.
x Keep the charging adapters dry and free of dirt/dust at all times. Do not submerge them in water or
any liquid.
x Do not overheat or overcharge the battery.
3
INTRODUCCIÓN
Lea y comprenda este Manual del Propietario antes de usar la Lámpara LED Recargable. Recargue
y opere la Lámpara LED Recargable sólo como se describe en este Manual de Propietario.
CARACTERÍSTICAS
5
1
4
2
3
6
9
7
8
Leyenda
1. Interruptor de ENCENDIDO/APAGADO
2. Imán
3. 30 Luces LED
4. Gancho Giratorio
5. Adaptador de Carga de 12 voltios CC
6. Fusible de 2A
7. Puerto de Carga
8. Indicador de Carga LED Rojo
9. Adaptador de Carga de 110/120 voltios CA
CARGA DE LA LÁMPARA LED RECARGABLE
AVISO
Esta Lámpara LED Recargable es despachada parcialmente cargada. ANTES
de usarla por primera vez, cargue la batería de la Lámpara LED Recargable usando el
adaptador de carga de 110/120 voltios CA durante 6 horas o durante 5 horas si está usando
el adaptador de carga de 12 voltios CC. El no cumplir con este procedimiento podrá dañar
permanentemente la batería.
Características del Cargador
El adaptador de carga de 110/120 voltios CA permite usar un tomacorriente doméstico (110/120
voltios CA). El adaptador de carga de 110/120 voltios CA se conecta al puerto de carga ubicado en la
parte inferior del mango de la Lámpara LED Recargable.
El adaptador de carga de 12 voltios CC permite cargar la batería usando el enchufe hembra del
encendedor de cigarrillos/accesorios de 12 voltios CC. El adaptador de carga de 12 voltios CC se
conecta al puerto de carga ubicado en la parte inferior del mango de la Lámpara LED Recargable. El
adaptador de carga de 12 voltios CC contiene un fusible de 2 amperios en el extremo del adaptador
para evitar daños causados por excesiva corriente mientras carga.
Un indicador de carga LED rojo se encuentra al lado de las 30 luces LED y mientras la Lámpara LED
Recargable está cargando, el indicador de carga LED rojo estará iluminado. Cuando la lámpara LED
quede completamente cargada, el indicador de carga LED rojo se apagará.
Normas y Precauciones de Carga
x Sólo use los adaptadores de carga que fueron suministrados con la Lámpara LED Recargable.
El uso de cualquier otro cargador o adaptador podrá anular la garantía, podrá causarle daños al
producto, aumentar el riesgo de incendio y/o resultar en lesiones corporales.
x Mantenga los adaptadores secos y libres de mugre/polvo en todo momento. No los sumerja en
agua o en ningún otro líquido.
x No recaliente o sobrecargue la batería.