PRO PRESS
INSTALLATION AND FUNCTIONING INSTRUCTIONS
1. PRODUCT DESCRIPTION
The device is an automatic pump controller designed for
hydraulic systems.
2. APPLICATIONS
The device finds its application in typical water supply systems
and rainwater systems in residential, buildings, gardening,
agriculture, and industry.
Before installing the device, read the instructions
carefully. The installer and the nal user must
observe the laws and standards, and make sure
that they comply with relative local regulations. The
device is assembled in compliance with existing
community laws and the Manufacturer declines any
liability in case of damage caused by incorrect use
or use in conditions diering from those indicated
on the nameplate and in these instructions.
WARNING:
• If these instructions are not observed, personal
injuries or death brought by electric shock may occur.
• This symbol means that an action must be taken.
• If these indications are not followed, damage or
failure of the device may occur.
• Suggestions and tips recommended to facilitate
the work.
3. TECHNICAL DATA
TECHNICAL DATA UP/PLUS VERSION
VOLTAGE 230 Vac
ACCEPTABLE VOLTAGE
FLUCTUATION
+/- 10%
FREQUENCY 50-60 Hz
MAXIMUM CURRENT 10 A
MAXIMUM POWER 1,5 kW (2 HP)
MAXIMUM RUNNING
PRESSURE
12 bar (1,2 MPa)
MAXIMUM RUNNING
TEMPERATURE
65°C
DEVICE 1C
PROTECTION DEGREE IP 65
DIMENSIONS Fig. 5
VOLTAGE THREE-PHASE 115/230 Vac
ACCEPTABLE VOLTAGE
FLUCTUATION
+/- 10%
FREQUENCY 50-60 Hz
MAXIMUM CURRENT 10 A
MAXIMUM POWER 0,75 Kw (1 HP) / 1,5 kW (2 HP)
Symbols and danger indications as listed
below are present in this instruction
manual.
fig 5
Device for control and protection
of the electric pump
To Next Page
General