Need help?Do you have a question about the Peavey EVH 5150 II and is the answer not in the manual?
General| Brand | Peavey |
|---|---|
| Model | EVH 5150 II |
| Category | Musical Instrument Amplifier |
| Language | English |
Provides AC power; connect to grounded supply. Do not remove ground pin.
Replace with same type (5A, 250V) only when power cord is disconnected. Seek qualified service for repeated blowing.
Three-position switch for hum reduction. Not functional on 220/240V models.
Connect speaker enclosures. Minimum impedance is 4 ohms. Use Impedance Selector Switch (5).
Sets speaker enclosure impedance (4, 8, 16 ohms). For multiple enclosures, set to half the value.
Supplies power to the unit. Red Power LED illuminates when power is supplied.
Places amp in non-operational standby mode. Keeps tubes hot. Standby LED illuminates when in operational mode.
To Next Page