Impulse
®
1015 Sub
Add-On Weather-Resistant
Injection-Molded Subwoofer
Speaker System
SPECIFICATIONS
Enclosure:
Peavey Impulse
®
1015 Subwoofer
Frequency Response:
Filtered:
50 Hz to 150 Hz
Unfiltered:
50 Hz to 2.8 kHz
Low Frequency Limit (-3 dB point):
50 Hz
Useable Low Frequency Limit (-10 dB point):
44 Hz
Power Handling:
Filtered:
2,000W peak
1,000W program
Unfiltered
2,000W peak
1,000W program
Sound Pressure Level (1W @ 1m, swept-sine
input in anechoic environment):
Filtered:
98 dB
Unfiltered:
101 dB (midrange level)
Maximum Sound Pressure Level:
Filtered:
125 dB
Unfiltered:
131 dB continuous
Transducer Complement:
Model 1508-4 SPS 15” Black Widow
®
woofer
Box Tuning Frequency:
44 Hz
SPECS
PEAVEY ELECTRONICS
Electroacoustic Crossover
Frequency (Filtered):
150 Hz
Crossover Slope:
12 dB/octave (2nd order) low pass,
Impedance (Nominal):
4 ohm
Impedance (Minimum):
3.35 ohm
Input Connections:
Filtered:
1/4” phone jack and 4-pin Neutrik
®
Speakon
®
connector in parallel
Unfiltered:
4-pin Switching Neutrik
®
Speakon
®
Enclosure Materials and Finish:
Injection-molded high-impact polypropy-
lene of a nominal thickness of 1/4” and
with textured finish
Mounting Provisions:
Stand mounting via molded-in
mount, flying via Versamount
®
70
(top or bottom of cabinet) and four
rubber feet for floor use.
Dimensions (H x W x D):
Front:
28.562” x 21.312” x 17”
72.55 cm x 54.13 cm x 43.18 cm
Rear:
11.5” wide
29.21 cm
Net Weight: 52 lbs.
Shipping Weight: 59 lbs.(EST.)
Additional Remarks:
Specifications for Impulse 1015 and the
Impulse 1015 Subwoofer system, sub-
woofer used in add-on mode via filtered
input
Frequency Response: 42 Hz to 18 kHz
Low Frequency Limit (-3 dB point):
42 Hz
Useable Low Frequency Limit
(-10 dB point):
37 Hz
To Next Page
Need help?
General
